Free Vocal EQ Cheat Sheet

How Falcon Acoustics Sound Panels Tightened Up Our Church’s Bass Response

In a nutshell

Treat bass problems at their source: measure your room, identify where low frequencies build up, then place treatment accordingly. In this church, eight rear-corner panels made bass tighter and more even. The key qualification: panel type, quantity, and placement must be based on your room’s measurements, not a universal recipe.

Kade Young
Kade Young
Chief Audio Guru
SHARE

Loading...

Where should we send it?

Check your email

Your free resource is on the way!
It should arrive within 1–2 minutes.
Check Promotions or Spam if you don’t see it.

Resource Not Found

We couldn't find this download.

Request a Quote from Falcon Acoustics →

Sound treatment is easy to put off. A new mixer or better speakers feel more exciting, but panels can make a real difference in how consistently the room responds.

After four years in our current auditorium, I finally invested in treatment—not because the room sounded terrible, but because the low end was not as tight or even as it could be.

Start With the Problem You Actually Hear

Our auditorium is narrow and has hard surfaces, yet it sounded surprisingly good without treatment.

The issue was not the mids and highs. What bothered me was the low-frequency response: bass felt a little swimmy instead of tight, and it was not consistent throughout the room.

That distinction matters. Don’t assume every hard-surfaced room needs the same amount or type of treatment. Listen for what is actually wrong.

In our case, some seats had too much bass while other people could barely hear it. The goal was not simply to put panels on the walls; it was to make the low end more even from the front to the back and side to side.

Measure the Room Before Deciding What to Install

I brought in acoustic-panel specialists from Falcon Acoustic Design Group to evaluate the room. They used a sound-measuring device that played pink noise in short and long bursts, then measured frequency-specific reflections in the room.

The tests were taken with a reference microphone in the middle of the room and again in the back corners. That gave us more useful information than judging the room from one listening position.

The midrange and upper frequencies had very short reflection times, while the low frequencies lasted longer. The biggest problem showed up at the back of the room.

That result confirmed what I was already hearing, but it also gave us a specific direction: address the low-frequency buildup in the rear corners rather than covering the room with panels just because panels seem like the right thing to buy.

What the Testing Led Us to Do

The recommendation for our room was eight panels in the back corners.

That is a room-specific recommendation, not a universal formula for every church. Your room may have a different trouble area and need a different solution.

The important takeaway is to identify which frequency range is lingering and where in the room it is most noticeable before choosing the number and placement of panels.

Why the Panel Design Matters

I have built my own panels before to save money. My DIY approach was to make a frame from furring strips and wrap mineral-wool insulation in burlap fabric. That kind of panel primarily gives you absorption.

This time, we installed Falcon Acoustic Curve Panels. They were designed by Porter Falcon after decades in the sound industry, with the understanding that room treatment is more than absorption alone.

These slightly curved panels are intended to work in three ways:

  • as a bass trap,
  • as a sound deflector, and
  • as an absorber.

That was the main reason I chose this route rather than building another set of basic panels myself.

Our issue was low-frequency control, so the bass-trapping and deflection aspects mattered in addition to absorption.

Make Treatment Fit the Room Visually, Too

Sound treatment stays on the wall, so it needs to work with the room rather than look like an afterthought.

The panels for our auditorium were custom-built to fit around a light switch and thermostat while keeping the design symmetrical. They also used premium fire-resistant fabric, with enough color choices to match the room.

That does not change the acoustic goal, but it does matter in a worship space. Good treatment should solve the sound problem without making the auditorium feel unfinished or cluttered.

Listen for a Tighter, More Even Low End

I had mixed in this room for almost five years, so I knew its response well. After the panels were installed, the change was much bigger than I expected. The bass that had sounded swimmy became tight, and the response became much more even throughout the room.

The practical result was fewer bass hot spots. Instead of one group of people being overwhelmed by low end while another group barely heard it, the bass was much more consistent from front to back and side to side.

We also repeated the same sound tests after installation to verify the improvement.

Use Panels and Room EQ Together

Sound panels and room EQ go hand in hand, but they do different jobs. Treatment addresses the room’s physical reflections and low-frequency behavior. Room EQ is another tool that helps shape the overall response of the system in that room.

In our case, panels took a room that already sounded good and made the low end tighter and more consistent.

If your church has a low end that feels loose, uneven, or dramatically different depending on where people sit, start by understanding the room’s behavior. Measure if you can, focus treatment where the problem is happening, and judge the result throughout the room—not only from the mix position.

Request a Quote from Falcon Acoustics →

2 Comments →

Leave a Reply

Your email address will not be published. Required fields are marked *

2 comments on “How Falcon Acoustics Sound Panels Tightened Up Our Church’s Bass Response”

  1. Thank you Kade for the sound panel tip . We reached out to Mike and Carrie at Falcon Acoustic Group and they came and tested our sanctuary. Wow , the delay times were all over the place . They installed 51 panels and the room now sounds amazing. I worked with another company before but they didn’t compare to Falcon . A very professional company that knows how to treat a room correctly and get the results you need . We here at Faith Church in Peru, Illinois highly recommend Mike and Carrie .

    1. Thanks for the feedback, Gary! I agree, Mike and Carrie are great.

© 

2026

Collaborate Worship. All rights reserved.